The way in which you connect your speakers to a computer depends on the type of computer you are using and on your operating system.
Connecting to a computer
Applies to:
IMPORTANT: Do not unplug any cables during this setup procedure.
- After plugging in the USB cable, wait for a series of "Found New Hardware" messages to appear on your computer screen (this takes about 30 seconds)
Note: If you do not see these messages, the capability to display them may be disabled on the computer. Wait two minutes before proceeding to the next step. - In the Windows® XP Control Panel, open "Sounds and Audio Devices Properties"
- Under the "Volume" tab, verify that "Bose USB Audio" is the connected USB device
- Under "Speaker settings", click the "Advanced" button to open "Advanced Audio Properties"
- In the "Speaker setup" drop-down list, select "5.1 surround sound speakers"
- Click "Apply" and then "OK". Your Companion® 5 multimedia speaker system is now ready to use
Note: If you remove the USB connection to your Companion® 5 system and plug it in again later, perform this procedure again to check the settings.
IMPORTANT: Do not unplug any cables during this setup procedure.
- Plug in the USB cable. Wait for the device driver installation message to appear on your computer screen
Note: If you do not see these messages, the capability to display them may be disabled on the computer. Wait two minutes before proceeding to the next step. - Click on the message to display the installation status. Wait for the installation to finish
- Open the control panel and click "Hardware and Sound"
- Click "Sound" in the "Hardware and Sound" control panel
- Verify that the Playback default setting (indicated by a green tick) is "Bose USB Audio". If not, select "Bose USB Audio" and click "Set Default"
Your Companion® 5 multimedia speaker system is now ready to use.
IMPORTANT: Do not unplug any cables during this setup procedure.
- In the "System Preferences", open the "Sound" control panel
- Choose "Bose USB Audio" for sound output and close the control panel
- In the Applications folder on your hard drive, open the Utilities folder
- Open the "Audio MIDI Setup" control panel
- Select "Bose USB Audio" for "Properties For", "Default Output" and "System Output"
Your Companion® 5 multimedia speaker system is now ready to use.